I N S T A L L A T I O N Standard AC Outlet Modular Jack AC Adapter Telephone Line Cord Power Cord 5 Connect the power cord. CAUTION: Use only AC power adapter supplied with this 3 Connect the telephone line cord. telephone.
O P E R A T I O N Wait for the light to go on before dialing a call. When you answer a call, you might not be able to hear your caller until the light goes on. Press to get dial tone and make a call —...
Page 4
O P E R A T I O N This light goes on when the handset is in the base, or when the handset is on a call. PAGE the handset from the base. When you press this but- ton, the handset sounds a 3-part tone. To activate the handset locator feature, press and hold the p button for 3 seconds.
Page 5
M E M O R Y This cordless phone can store 10 telephone numbers that Replacing a Stored Number you can dial just by pressing p and one of the num- You can replace a stored number by storing a new number ber buttons.
B A T T E R I E S Charging the Handset Battery Pack Replacing the Handset Battery Pack The batteries need charging when: Remove the battery case cover on the handset by The phone beeps four times when you press P. pressing on the indentation and sliding the cover •...
Page 7
C A S E D I F F I C U L T Y If you have difficulty operating this phone, try problem is probably in your wiring or local service. Call the suggestions below. If you still have trouble, call your local telephone service company.
O P E R A T I N G R A N G E This cordless telephone operates at the maximum power al- Changing Channels lowed by the Federal Communications Commission (FCC). This cordless telephone has an advanced 25-channel Even so, the handset and base can communicate over only a AutoSelect feature that minimizes the chance of certain distance —which can vary with the locations of the interference.
Need help?
Do you have a question about the 7235 and is the answer not in the manual?
Questions and answers