Brother BAS-342G Specifications page 3

Easy and accurate positioning of materials
By setting the work clamp operation to two-step
lowering, the work clamp can be lowered to
pause at an intermediate position and then
lowered to the lowest position. By setting an
optimal height for the intermediate position,
quick and accurate positioning of materials is
possible. This reduces additional clamping
operations due to incorrect positioning of the
material, shortening the total cycle time.
Stable thread tightening available with low-tension sewing
Stable thread tightening even with low-tension sewing has been realized, with the high-rigid feed
mechanism with servo control and the needle bar / thread take-up mechanism that has optimal
timing and stroke.
Uniform thread tightening even at overlapping parts of materials
The setting of the height of the stepping presser
foot can easily be made by putting a value on the
operation panel. By setting a suitable height of
the presser foot for the thickness of the material,
excessive or insufficient pressing by the presser
foot can be prevented, enabling a finish with
uniform thread tightening.
By using the programmer PD-3000*, the height
of the stepping presser foot can be set in sewing
data. The height can be set so that it changes
according to the changes of the thickness of the
material.
* The programmer is an optional product.
Adjustment of driver needle guard without tilting the machine head
The driver needle guard can easily be
adjusted from the side of the bed, without
tilting the machine head.
The adjustment of the clearance between the
needle and the hook tip is also possible with-
out tilting the machine head.
For adjustment For adjustment
of the clearance of the clearance
between the needle between the needle
and hook tip and hook tip
For adjustment For adjustment
of the driver of the driver
needle guard needle guard