HP Integrity rx5670 Installation Manual page 41

3. Click Add. The certificate appears under Certificate Files. You can click Save to save your
changes up to this point or click Cancel to discard the changes and close the wizard.
4. Click Next. The IP Binding page appears.
Trust by Name
HP SIM certificate names designated in the Trust By Name field. The Trust By Name option is
easy to configure. For example, you might use the Trust By Name option if you have a secure
network with two separate groups of administrators in two separate divisions. This option prevents
one group from installing software to the wrong system. This option verifies only the HP SIM server
certificate name submitted.
CAUTION: HP strongly recommends using the Trust by Certificate option because the other
options are less secure.
The server name option must meet the following criteria:
Each server certificate name must be less than 64 characters.
Special characters must not be included as part of the server certificate name: ~ '
! @ # $ % ^ & * ( ) + = \ ": ' < > ? , | .
To trust by name:
1. Select Trust by Name, and click Next.
2. In the Trusted Server Name field, enter the HP SIM server certificate name to be trusted.
3. Click Add. The trusted HP SIM server certificate name appears under the Trusted Servers
list. You can click Save to save your changes up to this point or click Cancel to discard the
changes and close the wizard.
4. Click Next. The IP Binding page appears.
Trust All Sets HP SMH to accept certain changes from any server.
CAUTION: HP strongly recommends using the Trust by Certificate option because the other
options are less secure.
To trust all servers:
1. Select Trust All. You can click Save to save your changes or click Cancel to discard the
changes and close the wizard.
2. Click Next. The IP Binding page appears.
9. IP Binding specifies from which IP addresses HP SMH accepts requests and provides control over which
nets and subnets requests are processed.
Administrators can configure HP SMH to bind only to addresses specified in the IP Binding page. You
can define a maximum of five subnet IP addresses and netmasks.
An IP address on the server is bound if it matches one of the entered IP Binding addresses after the mask
is applied.
NOTE: HP SMH always binds to 127.0.0.1. If IP Binding is enabled and no subnet/mask pairs are
configured, then the HP SMH is available only to 127.0.0.1. If IP Binding is not enabled, HP SMH
binds to all addresses.
To configure IP binding:
1. Select IP Binding. The IP Binding page appears.
2. Enter the IP address.
3. Enter the netmask.
Note: The masking field is not required for IPv6 addresses.
Sets HP SMH to accept certain configuration changes only from servers with the
Preconfiguring the HP SMH component 41