Dell PowerEdge 2800 Hardware Installation page 8

6
The daughter card fits between the sides of the card guide. To install the daughter card in
the card guide and to connect it to the backplane connector:
Ensure that the retention lever is in the open position.
a
Hold the daughter card by its edges with the card connector facing the SCSI backplane
b
and the retention peg facing the retention lever. See Figure 1-2.
Lower the card into the card guide.
c
Close the retention lever to slide the daughter card into the SCSI backplane connector
d
and lock the card into place. See Figure 1-2.
7
Rotate the drive bay retraction bar toward the front of the system. See Figure 1-3.
Figure 1-3. Drive Bay Retraction Bar
drive bay retraction bar
8
Reconnect the control panel cable to its backplane connector. See Figure 1-2.
9
To use the optional integrated ROMB controller in a split backplane configuration:
Connect channel A on the riser card to SCSIA on the SCSI backplane. This channel
a
controls the boot drive (drive 0) and drive 1.
Connect SCSI channel B on the riser card to connector SCSIB on the SCSI backplane.
b
This channel controls drives 2 through 5.
1-6
Installing the SCSI Backplane Daughter Card