Table of Contents
Advertisement
Installation I (In new construction) - continue
7.
Insert the attached exterior hood from the outside to cover
the wall sleeve, and secure it with four screws or nails.
Cover the seam between the wall sleeve and exterior
hood with aluminum tape, and apply mortar or caulking
around the exterior hood flange to prevent rainwater from
coming in. (Fig. 5)
8.
Using enclosed template (pattern paper), mark and cut
the opening in the interior wall cover. (Fig. 6)
9.
Press the mounting plate tightly against the wall and se-
cure to the outside of the wall sleeve with the supplied
screws(screw II). (Fig. 7)
10. Remove the grille from the fan unit.
Press the spring locks on the sides and pull the grille
back. (Fig. 8)
11. Attach the electrical connectors to each other, hook the
frame latches onto the mounting plate latch, and secure
the fan unit to the mounting plate with the supplied screw
(screw III). (Fig 9)
CAUTION:
Do not pinch the power cord with the frame.
12. Reattach the grille to the frame.
CAUTION:
Press on the grille until it clicks.
NOTE:
Be sure to paint the exterior hood. Before painting, thor-
oughly wipe off any oil on the surface. Also make sure that
the paint does not enter inside of the hood.
Aluminum
tape
Interior wall
material
Frame
6
Exterior hood
Finish with mortar
or caulk.
Seam
Grille
Fan unit
(Frame)
Latch
Mounting plate
Latch
Grille
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Hide quick links:
Advertisement
Table of Contents
