Table of Contents
Advertisement
Specifications
Model
Air direction
FV-08WQ1
Exhaust
*1
At 0.0" Static pressure, (Pa)
Unpacking
Unpack and carefully remove unit from the carton. Refer to list of components to verify that all parts were supplied.
General safety precautions
1.
Do not install this ventilating fan where air temperature may exceed 104 F. (40 C)
2.
Make certain that the nominal service voltage is 120V 60 Hz.
3.
Follow all local electrical and safety codes, as well as the National Electrical Code (NEC) and the Occupation Safety and Health
Act (OSHA).
4.
Always disconnect the power source before working on or near the fan, motor or junction box.
5.
Protect the power cord from sharp edges, oil, grease, hot sur-
faces, chemicals, or other objects.
6.
Do not kink the power cord.
7.
Provide suction parts with proper ventilation.
8.
This unit is acceptable for use over a bathtub or shower when
installed in a GFCI protected branch circuit.
CAUTION:
1. For general ventilating use only. Do not use to exhaust hazard-
ous or explosive materials and vapors.
2. Not for use in cooking area. (Fig. A)
3. This product must be grounded.
4. To reduce the risk of injury to persons, install fan at least 7 - 10
feet (2.1 - 3.05 meters) above the floor.
WARNING:
To reduce the risk of fire, electric shock, or injury to persons, observe the following;
A. Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.
B. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and
standards, including fire-rated construction.
C. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning
equipment to prevent backdrafting. Follow the heating equipment manufacturer's guideline and safety standards such
as those published by the National Fire Protection Association (NFPA), and the American Society for Heating Refrigera-
tion and Air Conditioning Engineers (ASHRAE), and the local code authorities.
D. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
E. If this unit is to be installed over a tub or shower, it must be marked as appropriate for the application.
F. Do not use this fan with any solid-state speed control device.
G.Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the service panel.
H. NEVER place a switch where it can be reached from a tub or shower.
V
Hz
Power consumption
120
60
17
*2
For main unit only.
*1
(W)
Speed
*1
Air delivery at 0.03"WG
(r/min.)
1340
4
Noise
(CFM)
70
1.1
(Cooking area)
Do not install above or
inside this area.
Floor
Cooking
equipment
Fig. A
Weight
*2
lb. (kg)
3.1
(1.4)
Hide quick links:
Advertisement
Table of Contents
