Frigidaire FGHB2844LE Wiring Diagram

PERFORMANCE DATA NO LOAD & NO DOOR OPENINGS AT 37°/0° CONTROL SETTING
Type A with Run/Start Capacitor 65°F (18°C) Ambient
Operating Time 74 to 84%
Freezer Temperature -5° to 2° F (-20° to -17° C)
Refrigerator Temperature 34° to 39° F (1° to 4° C)
Low Side Pressure (cut-in) 5 to 12 psig (34 to 83 kPa)
Low Side Pressure (cut-out) -2 to 2 psig ( -14 to 14 kPa)
High Side Pressure (last 1/3 cycle) 85 to 95 psig (586 to 655 kPa)
Wattage (last 1/3 cycle) 45 to 55
Amps (running) .6 to 1.1
Base Voltage 115 vac (127 vac max)
deFrOst speciFicatiOns
thermostat
Cabinet Size
Cut-in Cut-out
26' & 28' SD, 23' CD 25° F (-4° C) 47° F (8° C)
Electronic Timer - (ADC) Defrost 24 minutes every 6-96 hours of compressor run time.
cOndenser Fan MOtOr
Watts rpM
3.1 1100 CW Opposite Shaft
ice MaKer speciFicatiOns
Electrical 115 vac (127 vac max)
Thermostat Opens at 48° F ( 9° C), Closes at 15° F ( -9° C)
Heater Voltage 85 vac
ice MaKer cOnnectOr pLUG cOnnectiOns
Wire number Wire color
1 Green/Yellow
2 Yellow
3 Black
4 Light Blue
iMpOrtant saFety nOte
The information provided herein is designed to assist qualified repair personnel only.
Untrained persons should not attempt to make repairs due to the possibility of electrical
shock. Disconnect power cord before servicing this appliance.
iMpOrtant
If any green grounding wires are removed during servicing, they must be returned to
their original position and properly secured.
caUtiOn
all electrical parts and wiring must be shielded from torch flame. dO nOt allow
torch to touch insulation; it will char at 200°F and flash ignite (burn) at 500°F.
excessive heat will distort the plastic liner.
nOte
This product comes equipped with an Adaptive Defrost Control (ADC). To activate manual
defrost, simultaneously press and hold the Fresh Food up (+) and Fresh Food down (-)
keys for 5 seconds. A "d" in the freezer temperature window and "F" in the refrigerator
temperature window will display when the heater is activated. To deactivate manual
defrost, simultaneously press and hold the Fresh Food up (+) and Fresh Food down (-)
keys for 5 seconds. A "d" and "F" will be displayed until the defrost cycle is complete.
iMpOrtant
pLease retUrn this sheet tO it's OriGinaL LOcatiOn.
90°F (32°C) Ambient
100%
ice & Water - aUtOMatic deFrOst
-1° to 3° F (-18° to -16° C)
34° to 39° F (1° to 4° C)
N/A
ice Maker errors displayed on "Ui"
-2 to 2 psig (-14 to 14 kPa)
120 to 135 psig (827 to 931 kPa)
errOr
60 to 70
ice er IM/RAM Error (on POR only)Detection – on POR
only. This error is detected as "no com/data link with
.7 to .9
IM" by ERF 2500++ system controller (PB).
ice ip Invalid Protocol (this error is detected when the
version of I/M pcb does not match version of 2500++
system controller)
ice ce IM Com Lost only after POR(no communication
between the I/M pcb and the 2500++ system
controller.)
heater
ice t3
TH3 Error (open or short) This error is detected
when the thermister has failed on the suction line
Watts Ohms
of the I/M.
500 31
amps
system error codes displayed on "Ui"
0.03 Running
errOr
Op or 2 Freezer Sensor OPEN
sh or 3 Freezer Sensor SHORTED
Op or 2 FF Sensor OPEN
sh or 3 FF Sensor SHORTED
sy eF Evaporator Fan Circuit
sy ce Communication error
sy cF
Communication error
dF In Manual Defrost
To initiate manual defrost press and hold, for 5 sec. FF(+) and FF(-), (d) and (f)
connects to:
will be displayed.
Ground
Water Valve
FREEZER iCE MAKER iNFORMATiON
Line
Test Cycling:
Neutral Remove cover by inserting
screwdriver in notch at bottom and prying cover
from housing. Use screwdriver to rotate motor
gear counterclockwise until holding switch circuit
is completed. All components of ice maker should
function to complete the cycle.
Water Fill Volume:
ment screw will change the fill time. One full turn
is equal to 20cc (.68 oz.). The correct fill is 102
to 130cc (3.4 to 4.3 oz.). When a water valve is
replaced, the fill volume must be checked.
LINE
BLK
P-3
THERMAL
CUT-OUT
GRN / YEL
P-1
MOLD
service data sheet
240389643
BOttOM FreeZer - r134a
diagnostic Mode note: see service Manual for
complete description.
test Activate: Hold FF (+) and FZ (+)
for 5 sec.
48c Freezer Recover Mode, "1" ok 57c Fan test, on or off
"Fr" Recovery mode, Icemaker in
"off" state. (See Note)
49c EEV On=Open Off=Closed , EEV 58c Ice level sensor switch test
must be in the open state for sealed
system evacuation.
50c 59c
Com Link "1" ok "ER" error Fill limit switch test
(See Note)
51c "ER" Replace 60c
TH1 Status "1" ok Freeze limit switch test
(See Note)
52c TH3 Status "1" ok "ER" Replace 61c IM evap heater test
54C Mold heater test, on or off 62c EEV test
56c Finger evap heater, on or off 63c Harvest motor system test
(See Note)
55c Water valve test (See Note) 64c Software version
de-activate: hold FF (+) for 5 sec.
diagnostic Mode note: see service Manual for
complete description.
test activate: FZ (+) and FZ (-) for
5 sec.
1 Standard compressor 22 Damper
2 Defrost heater 23 Fresh food door
3 FF lighting 24 Freezer door
8 Water valve,water disp. 26 Defrost limit switch
9 FZ lighting 28 Dispenser paddle
10 Auger motor 36 Ice door
11 29
Cube/crush solenoid FF Thermistor
41 Perfect Temp Drawer 30 FZ Thermistor
12 VCC Condensor fan 33 Ambient Thermistor
38 0-
VCC Compressor Software version
15 Evaporator fan
de-activate: hold FF (+) for 5 sec.
Water Fill
Adjustment
Motor
Gear
The water fill adjust-
Mounting
Plate
Screw
POWER NEUTRAL
ICE MAKER
BRN
MOTOR
RED
HOLD
SWITCH
YEL
NO
P-4
RED
THERMOSTAT
NC
C
NO
BLU
BLK
NC
C
MOLD HEATER
SHUT-OFF
165 WATTS
NO
SWITCH
NC LT. BLU
C
P-2
WATER FILL
MOUNTING
SWITCH
PLATE
ICE MAKER
FF Ice Maker
(2419801)
Mounting
Plate
Screws
Timing
Gear