Controlling the projector through a LAN
environment
This function is only available for the PJD6223/PJD6253/PJD6353/PJD6383/PJD6553w/
PJD6653w/PJD6683w series.
Settings
Configuring the LAN Control Settings
If you are in a DHCP environment:
MENU/EXIT
Projector IP Address Subnet Mask Default Gateway
Address
•
If the Projector IP Address still does not appear, contact your network administrator.
•
If the RJ45 cables are not properly connected, the Projector IP Address, Subnet Mask,
Default Gateway, and DNS Server settings will display 0.0.0.0. Make sure the cables are
properly connected and perform the procedures above again.
•
If you need to connect to the projector in its standby mode, set Power Saving to Off.
(An example of connection)
SYSTEM SETUP: Basic
LAN Control Settings
Enter
DHCP
Apply
39
T Y P
E B
U S B
L A N
R S -
Menu
MODE/ENTER
LAN Control Settings
On
MODE/ENTER
LAN Control Settings
LAN Control
2 3 2
Enter
DNS Server
Projector IP