Connecting Power Supply; Turning On The Power - Hitachi CP-RX78 Operating Manual

Connecting power supply

1. Put the connector of the power cord into the
AC IN (AC inlet) of the projector.
2.
outlet. In a couple of seconds after the
power supply connection, the POWER indicator
will light up in steady orange.
activated, the connection of the power supply make the
projector turn on.
WARNING
your dealer to get a new one.
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.

Turning on the power

1.
and correctly connected to the projector
and the outlet.
2. Make sure that the POWER indicator is
steady orange.
3. Press the STANDBY/ON button on the
projector or the remote control.
The projection lamp will light up and the
POWER indicator will begin blinking in
green. When the power is completely on, the
indicator will stop blinking and light in steady
green.
WARNING
not look into the lens of the projector or look inside of the projector through any
of the projector's openings.
NOTE
in the CD.
8
Please use extra caution when connecting the power cord, as
AC IN Power cord
STANDBY/ON button
POWER indicator
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH
MAGNIFY FREEZE PAGE
ON
OFF
KEYSTONE MY BUTTON
1
POSITION
ENTER
ESC
BLANK
VOLUME
UP
DOWN
MUTE
2
MENU
RESET