Hitachi CP-RX78 Operating Manual page 84

Replacing the lamp (continued)
HIGH VOLTAGE
WARNING
can break with a loud bang, or burn out, if jolted or scratched, handled while hot, or
worn over time. Note that each lamp has a different lifetime, and some may burst or
burn out soon after you start using them. In addition, if the bulb bursts, it is possible
About disposal of a lamp: This product contains a mercury lamp; do not put
it in a trash. Dispose of it in accordance with environmental laws.
or www.eiae.org (in the US) or www.epsc.ca (in Canada).
unplug the power cord from the outlet, and make sure to request a
replacement lamp from your local dealer. Note that shards of glass
could damage the projector's internals, or cause injury during handling,
so please do not try to clean the projector or replace the lamp yourself.
Disconnect
the plug
ventilate the room well, and make sure not to inhale the gas or fine
from the
particles that come out from the projector's vent holes, and not to get
power
them into your eyes or mouth.
outlet
cord, then wait at least 45 minutes for the lamp to cool sufficiently.
Handling the lamp while hot can cause burns, as well as damaging the lamp.
Never unscrew except the appointed (marked by an arrow) screws.
Do not open the lamp cover while the projector is suspended from a ceiling.
This is dangerous, since if the lamp's bulb has broken, the shards will fall out
when the cover is opened. In addition, working in high places is dangerous, so
ask your local dealer to have the lamp replaced even if the bulb is not broken.
replacing, make sure that the screws are screwed in firmly. Loose
screws could result in damage or injury.
that there are electrical problems elsewhere besides the lamp. If this
happens, consult your local dealer or a service representative.
Handle with care: jolting or scratching could cause the lamp bulb to burst during use.
up or to burst. When the pictures appear dark, or when the color tone
is poor, please replace the lamp as soon as possible. Do not use old
(used) lamps; this is a cause of breakage.
HIGH TEMPERATURE
The projector uses a high-pressure mercury glass lamp. The lamp
www.lamprecycle.org (in the US).
HIGH PRESSURE
13