Lexmark CX310 Compatibility Manual page 63

Printer specifications
The following table lists the maximum weights supported by the trays and the multipurpose feeder.
Overview of card stock and label support
Labels
Card stock
Media specifications
Labels Width:
Length:
Weight:
Thickness:
Smoothness:
* 150–250 Sheffield is optimal. Using media higher than 300 Sheffield could result in print quality
degradation.
Card stock Width:
Length:
Weight:
Card stock and label guidelines
When printing on labels:
•
Load labels only on the multipurpose feeder.
•
From the printer control panel, set Paper Type to Labels in the Paper Menu.
• Do not use label sheets with a slick backing material.
•
Do not print within 1 mm (0.04 in.) of the die‑cut, the edge of the label or the perforations, or between the die‑cuts.
•
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a paper jam.
•
Do not use label sheets that have adhesive to the edge of the sheet. We recommend zone coating of the adhesive
at least 1 mm (0.04 in.) away from the edges. Adhesive material may contaminate your printer and could void your
warranty.
When printing on card stock:
•
From the printer control panel, set Paper Type to Card Stock.
•
Do not use creased card stock. It may cause paper jams.
•
We recommend the use of grain long card stock.
Tray 1
Not applicable
2
105 g/m
210–216 mm (8.3–8.5 in.)
279–356 mm (11–11.7 in.)
120–128 g/m
0.13–0.20 mm (0.005–0.008 in.)
100–400 Sheffield*
210–216 mm (8.3–8.5 in.)
279–356 mm (11–11.7 in.)
Up to 220 g/m
Trays 2 and 3
Not applicable
2
220 g/m
2
2
Multipurpose feeder
2
220 g/m
2
220 g/m
63