Samsung HT-D423H User Manual page 31

DSP (Digital Signal Processor)/EQ
•
DSP (Digital Signal Processor) : DSP modes have
been designed to simulate different acoustic
environments.
•
EQ : You can select POPS, JAZZ , ROCK, or USER
to optimize the sound for the genre of music you are
playing.
Press the DSP/EQ button.
POPS, Select POP, JAZZ, or ROCK,
JAZZ, depending on the genre of music
ROCK you're listening to.
You can enjoy music as you set in
"EQ:USER ".
If you press ENTER in the "EQ:USER"
USER
menu, you will see a window where you
can change the EQ settings to your
preference.
Provides a sense of presence as if in a
STUDIO
studio.
Simulates the sound of a dance club
CLUB
with a throbbing bass beat.
Provides a clear vocal as if listening in a
HALL
concert hall.
MOVIE Provides the feeling of a movie cinema.
Provides the feeling of being in a
CHURCH
grand church.
OFF Select this for normal listening.
✎
NOTE

The DSP/EQ function is only available in Stereo
mode.

The DSP/EQ function is not available while
playing AC3 signal in 2.1 channel mode.
HT-D423H-XU-ENG-1228.indd 31 HT-D423H-XU-ENG-1228.indd 31
Listening to Radio
Using buttons on the Remote Control
1. Press the FUNCTION button to select FM.
2. Tune in to the desired station.
•
Preset Tuning 1 : You must fi rst add a desired
DSP /EQ
frequency as a preset. Press the STOP () button
to select PRESET and then press the TUNING/
CH ( ) button to select the preset station.
•
Manual Tuning : Press the STOP () button to
select MANUAL and then press the TUNING/CH
( ) button to tune in to a lower or higher
frequency.
•
Automatic Tuning : Press the STOP () button
to select MANUAL and then press and hold the
TUNING/CH (
the band.
Setting Mono/Stereo
Press the MO/ST button.
•
Each time the button is pressed, the
sound switches between STEREO and
MONO.
•
In a poor reception area, select MONO for a clear,
interference-free broadcast.
Presetting Stations
Example : Presetting FM 89.10 in the memory
1. Press the FUNCTION button to select FM.
2. Press the TUNING/CH (
<89.10>.
3. Press the TUNER MEMORY button.
•
Number fl ashes on the display.
4. Press the TUNING/CH (
to select preset number.
•
You can select between 1 and 15 presets.
5. Press the TUNER MEMORY button again.
•
Press the TUNER MEMORY button before
number disappears from the display.
•
Number disappears from the display and the
station is stored in memory.
6. To preset another station, repeat steps 2 to 5.
) button to automatically search
) button to select
) buttons
31
English
2011-12-28 2011-12-28 4:18:20 4:18:20