At The End Of Programme; Cancelling A Programme; Auto Stand-By Option - Electrolux EWF 1486 GDW User Manual

14 www.electrolux.com

9.8 Cancelling a programme

1.
Press the button
onds to cancel the programme and to
deactivate the appliance.
2. Press the same button again to acti-
vate the appliance. Now, you can set
a new washing programme.
The appliance does not drain the
water.
9.9 Opening the door
While a programme or the delay start op-
erates, the appliance door is locked and
the display shows the indicator
CAUTION!
If the temperature and level of the
water in the drum are too high,
you cannot open the door.
Open the appliance door when the
delay start operates:
1. Press
2.
Wait until the door lock indicator
goes off.
3. Open the door.
4.
Close the door and press
The delay start continues to operate.
Open the appliance door when the
programme operates:
1.
Press the button
onds to deactivate the appliance.
2. Wait for some minutes and then open
carefully the appliance door.
3. Close the appliance door.
4.
Set the programme again.
9.10 At the end of the
programme
• The appliance stops automatically.
• The acoustic signal operates (if it is acti-
vated).
• In the display a
• The indicator
• The door lock indicator
• Remove the laundry from the appliance.
Make sure that the drum is empty.
for some sec-
to pause the appliance.
again.
for some sec-
comes on.
goes off.
goes off.
• Keep the door ajar, to prevent the mil-
dew and odours.
• Close the water tap.
• Press the button
to deactivate the appliance.
The washing programme is
completed, but there is water in the
drum:
– The drum turns regularly to prevent the
creases in the laundry.
– The door lock indicator
door stays locked.
– You must drain the water to open the
door.
.
To drain the water:
1. If necessary, decrease the spin
speed. If you set
ance only drains.
2. Press
water and spins.
3. When the programme is completed
and the door lock indicator
goes off, you can open the door.
4.
Press the button
onds to deactivate the appliance.
The appliance drains and spins
automatically after approximately
18 hours (except for Wool pro-
gramme).

9.11 AUTO Stand-by option

The AUTO Stand-by option automatically
deactivates the appliance to decrease the
energy consumption when:
• You do not use the appliance for 5 mi-
nutes before you press
Press the button
pliance again.
• After 5 minutes from the end of the
washing programme
Press the button
pliance again.
The display shows the end of the last
set programme.
Turn the programme knob to set a new
cycle.
for some seconds
is on. The
, the appli-
. The appliance drains the
for some sec-
.
to activate the ap-
to activate the ap-