Technical Information - Electrolux EWF 1486 GDW User Manual

Problem
The appliance fills with
water and drain imme-
diately.
The washing results
are not satisfactory.
After the check, activate the appliance.
The programme continues from the point
of interruption.
If the problem occurs again, contact the
Service.

13. TECHNICAL INFORMATION

Dimensions
Electrical connection:
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, except
where the low voltage equipment has no protection
against moisture
Water supply pressure
Water supply
Maximum load
Spin speed
1) The appliance works correctly if the water pressure is not less than 0.05 MPa (0.5 bar).
If you can not connect the water inlet hose to the cold water tap of the primary hydraulic
system, connect it to your domestic cold water storage system.
Make sure not to have more than a distance of 5.02 m (16.5 ft) between the appliance inlet
hose and the bottom of the water storage tank.
2) Connect the water inlet hose to a water tap with a 3/4'' thread.
Possible solution
Make sure that the packaging and/or the transit bolts are
removed. Refer to 'Installation'.
Add more laundry in the drum. The load may be too
small.
Make sure that the drain hose is in the correct position.
The hose may be too low.
Increase the detergent quantity or use a different deter-
gent.
Use special products to remove the stubborn stains be-
fore you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Width / Height / Depth
Total depth
Voltage
Overall power
Fuse
Frequency
1)
Minimum
Maximum
2)
Cotton
Maximum
If the display shows other alarm codes.
Deactivate and activate the appliance. If
the problem continues, contact the Serv-
ice.
600 / 850 / 605 mm
ENGLISH 21
640 mm
230 V
2200 W
10 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
8 kg
1400 rpm