Install Mower And Drive Belt - Craftsman 28974 - Professional PGT 9000 28 HP/54" Garden Tractor Operation Manual

iCONTROLDE
:)preajustado en
ajustes. Revise
_tinuaci6n, antes
neoesario, yea
)NTROL
DE
sido preajustado
itar ajustes.
kDOR
do en la fa'brica
_in embargo, se
nor importancia
_sen el combus-
Si el carburador
de motor,
INSTALL MOWER AND DRIVE
BELT
See MOWER AND DRIVE BELT AS-
SEMBEY Supplement Sheet for additional
guidance on this assembly.
Be sure tractor is on level surface and
engage parking brake.
1. Lower attachment lift lever to it's lowest
position.
CAUTION: Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
2, Turn steering wheel to the left as far as it
will go and position mower on right side
of tractor with deflector shield to the right.
- Pivot bar towards you and insert other
end of bar into hole in rear mower
bracket (D). Move mower as needed to
insert bar.
- Secure with washer and retainer
spring as shown.
3. Remove plastic tie securing belt, bring
belt forward and check belt for proper
routing in all mower pulley grooves.
!
6. ATTACH MOWER SIDE SUSPENSION
ARMS (A) TO CHASSIS- Position hole
in arm over pin (B) on outside of tractor
chassis and secure with washer and
retainer spring.
7. Repeat on opposite side of tractor.
NOTE: Be sure mower side suspension
arms (A) are pointing forward before slid-
ing mower under tractor.
4. Slide mower under tractor until it is
centered under tractor.
5. FIRST INSTALL ANTI-SWAY BAR (S).
- From right side of mower, insert
ant-sway bar into hole in transmission
bracket (T).
9