Lubrication - Echo GT-230 Operator's Manual

Echo trimmer user manual

Hide thumbs Also See for GT-230:

Table of Contents

Check idle speed and reset if necessary. If a tachometer is avail-

able, idle speed screw (A) should be set to the specifications found

on page 12 "Specifications" of this manual. Turn idle screw (A)

clockwise to increase idle speed; counter clockwise to decrease idle

speed.

WARNING

When carburetor adjustment is completed, the cutting attachment

should not turn at idle, otherwise serious personal injury may

result.

LUBRICATION

Level 1.

Tools Required: 8 mm Open End Wrench, Screwdriver, Clean Rag.

Parts Required: ECHO

Grease.

Remove plastic shield.

Loosen bearing housing locating screw (A), at the top of the

housing, remove mounting screw (B).

Pull the flexible drive shaft (C) from the housing, wipe clean and re-

coat with a thin coating 1/2 oz. (15 ml) of grease.

Slide the flexible drive shaft back in the drive housing being careful

not to get dirt on the flexible drive shaft.

Install the bearing housing and shield.

DANGER

LUBE

8 oz. (P/N 91014) or Lithium Base

Table of Contents