Assembly; Plastic Shield; Nylon Head; Front Loop Handle - Echo GT-230 Operator's Manual

A
SSEMBLY
Tools Required: Locking Tool

PLASTIC SHIELD

1. Snap the shield over the bearing housing.
2. Install bolt (A), washer (B) and wing nut (C).
NYLON LINE HEAD
1. Remove plastic sleeve from threaded shaft.
2. Align locating hole in locating plate with hole in bearing housing.
3. Insert 1/8" dia. locking tool (D) (not included with unit) and thread
cutting attachment onto shaft clockwise until head is tight.
IMPORTANT
Remember to remove the locking tool.
( )
FRONT LOOP HANDLE
NOTE
Front handle is pre-installed. Repositioning and tightening is all
that is required.
1. Position front handle (E) in comfortable operating position and
tighten wing nut (F). The cutting attachment should be 5 - 7.5cm
(2 - 3 in.) above the ground and as level as possible.
G T
RASS RIMMER
O ' M
PERATOR S
B
C
D
F
13
ANUAL
A
E