Table of Contents
Advertisement
Changing Remote Control ID
In a multi-DVR system using a single remote control, you can control only the DVR that matches the ID that
you have set using the ID button.
1.
Press the [ID] button to check the ID of each of "REMOCON ID" and "SYSTEM ID".
The defaults are 00 for the System ID and 00 for the Remote ID, respectively.
2.
To change the Remote ID of the IR REMOTE CONTROLLER, press and hold the [ID] button while entering
a desired combination of two digits from 00 to 99.
3.
To change the ID of the DVR, refer to "REMOTE CONTROLLER > REMOTE CONTROLLER ID".
(Page 26)
4.
Press the ID button of the IR REMOTE CONTROLLER to check the ID.
M
If the system number defined in "REMOTE CONTROLLER" is different from the number specified using the remote
control, no other button than the [ID] buttons will operate.
English _13
- Quick Links:
- Network Connection
Hide quick links:
Advertisement
Table of Contents
