Reversing Door - Frigidaire FRQG7000LW Installation Manual

8 Remove lens locating screw. (Figure 7)
9 Disengage several of the retention tabs and pull lens
away from the transition ring. (Figure 8)
Figure 9
10 Remove two transition ring plugs and reinstall on
previous handle side. Figures 9 and 10)
11 Reassemble lens to transition ring with holes to install
handle on right-hand side of door assembly. Ensure
retention tabs on transition ring are snapped in place
on top of lens.
Figure 7
Figure 8
Figure 10

REVERSING DOOR

Figure 11
12 Reassemble outer door to inner door. (Figure 11)
13 Install four screws securing hinge to door assembly in
the new location, take note to place hinge in correct
orientation.
14 Install four screws into holes that had secured the
hinge.
15 Remove striker and discard.
16 Remove square plug and reinstall in hole striker was
just removed from.
17 Install new striker (included in literature bag) into hole
square plug was previously installed in.
18 Reinstall door handle by placing the handle mounting
bosses through holes in lens and transition ring and
installing screws through inner door and tighten into
handle bosses. (Figure 12)
19 Grasping fi rmly the top of the door, position the door
near the door opening and align the top hinge hole to
the top hole in the front panel door opening. Once the
fi rst screw is started, attach the second screw to the
lower hinge. Once both screws are tightened, install the
remaining two screws.
20 Install four plugs into the front panel door opening
where hinges were originally installed.
Figure 12
19