Lexmark 20G0100 - T 640 B/W Laser Printer Manual page 47

Message
37 Insufficient memory to collate
job
37 Insufficient memory for Flash
Memory Defragment operation
37 Insufficient memory, some held
jobs were deleted
37 Insufficient memory, some held
jobs were lost
38 Memory Full
39 Page is too complex to print
50 PPDS font error
51 Defective flash detected
52 Not enough free space in flash
memory for resources
53 Unformatted flash detected
54 Serial option <x> error
54 Network <x> software error
54 Standard network software error
Understanding printer messages
Action
• Press to print the portion of the job already stored and begin
collating the rest of the job.
• Cancel the current job.
• Press to stop the defragment operation and continue printing.
• Delete fonts, macros, and other data in printer memory.
• Install additional printer memory.
The printer deleted some held jobs in order to process current jobs.
Press until
message.
The printer was unable to restore some or all of the confidential or held
jobs on the hard disk.
Press to clear the message.
• Press to clear the message and continue printing.
The job may not print correctly.
• Cancel the current job.
• Install additional printer memory.
• Press to clear the message and continue printing.
The job may not print correctly.
• Cancel the current job.
• Install additional printer memory.
• Press to clear the message and continue printing.
The job may not print correctly.
• Cancel the current job.
Press to clear the message and continue printing.
You must install different flash memory before you can download any
resources to flash.
• Press to clear the message and continue printing.
Downloaded fonts and macros not previously stored in flash memory
are deleted.
• Delete fonts, macros, and other data stored on the flash memory.
• Install a larger capacity flash memory card.
Press to clear the message and continue printing.
You must format the flash memory before you can store any resources
on it. If the error message remains, the flash memory may be defective
and require replacing.
• Make sure the serial link is set up correctly, and you are using the
appropriate cable.
• Make sure the serial interface parameters (protocol, baud, parity, and
data bits) are set correctly on the printer and host computer.
• Press to clear the message and continue printing.
The job may not print correctly.
• Turn the printer off and then on to reset the printer.
• Press to clear the message and continue printing.
The job may not print correctly.
• Program new firmware for the network interface.
• Reset the printer.
47
Continue appears, then press to clear the