Dell PowerEdge 1750 Hardware Installation Manual page 29

Using a #2 Phillips screwdriver and an 11/32-inch wrench or nut driver, remove two
2
12-24 x 0.5-inch pan-head Phillips screws, two nuts, and two shoulder washers from
each front center bracket (see Figure 1-17).
Remove the front bracket from both slide assemblies.
3
Place the bracket from one slide assembly onto the threaded studs on the opposite
4
slide assembly, with the bracket turned 180 degrees so that the mounting flange faces
forward (see Figure 1-17).
Secure each front center mount bracket (by its nuts and shoulder washers) finger tight
5
on their opposite slide assemblies using the two shoulder washers and two nuts you
removed in step 2 (see Figure 1-17).
Join the front brackets you just installed to the bracket on the slide assembly with the
6
two 12-24 x 0.5-inch pan-head Phillips screws you removed in step 2 (see Figure 1-17).
The joined bracket becomes the new extended rear bracket.
Repeat steps 4 through 6 to configure the other slide assembly.
7
F i g u r e 1 - 1 7 . R o t a t i n g t h e F r o n t M o u n t i n g B r a c k e t f o r F l u s h - M o u n t
I n s t a l l a t i o n
nuts (2 per bracket)
shoulder washers
(2 per bracket)
mounting flange
12-24 x 0.5-inch pan-head Phillips screws
(remove 2 per bracket)
NOTE: These screws are shown reinstalled on
other slide assembly.
Rack Installation Guide
1-23