Power Outage - GE JGB900 - Appliances 30 in. Gas Range Owner's Manual

Usingthe oven.
Toavoid possible bums, place the shelves in the desired position before you turn the oven on.
Before you begin...
The shelves have stop-locks, so that when
placed correctly on the shelf" supports (A
through E), the} will stop before confing
completely ()tit, and will not flit.
_,\qtell placing and renlo_ino_ cookware,
pull the shelf out to the bump on the shelf
support.
To remove a shelf, pull it toward you, tilt the
fl'ont end up and pull it out.
To replace, place the end of the shelf (stoi>
locks) on the support, flit up the fl'ont and
push the shelf in.
NOTE: Theshelf is not desl)ned to slide out at the
special low shelf (R)position.
The oven has 5 shelf positions.
It also has a special low shelf
position (R)for extra large items,
such as a large turkey.
Plastic items on flTecooktop may
melt if left too close to the vent.
Vent appearance and location varg
Oven Vent
Your oven
is vented through ducts at the
rear of the range. Do not block these ducts
when cooking in the oven--it is important
that the flow _ff hot air ti'om the oven and
ti'esh air to the oven bm'ner be
uninterrui)ted. Avoid touching the vent
oi)enings
or neaYbv StlYJ[ilces
dtlIJng ()veil or
broiler operation--they may become hot.
!;>Handles of potsandpanson thecooktop may
become hot if lefi toocloseto thevent
iJi:: D o not leave plastic or flammable items on the
cooktop--they may melt or ignite if left too close
to the vent
iJi:: D o not leave closed contalbers on the cooktop.
Thepressure lb closed contalbers may increase,
which may cause them to burst.
iJi:: Metal itemswill become very hot if theyare left
on thecooktop, a ndcouldcause bums.
Power Outage
CAUTION: D onotmakeanyattemptto operatethe
electricignitionovenduringan electrical power
failure.
The oven or broiler cannot be lit during a
power fidlure. (;as will not flow unless the
glow bar is hot.
If the oven is in use when a power tifilure
occm_, the oven burner shuts off and
cannot be re-lit until power is restored. This
is beca use the flow of gas is a utomaflcallv
stopped and will not resume when power is
restored
tmtil the glow bar has reached
operating temperature.
Oven Light
Touch the OVEN LIGHTpad on the upper
control panel to turn the light on or off'.
On some models, the OVEN LIOHTswitch is
on the lower fl'ont control panel.
12