GE JGB900 - Appliances 30 in. Gas Range Owner's Manual page 52

,O
,O
{
,O
,O
iii;;{!!!iii_i!iiiiiiiiiiiii_i
iiiiHl! iiiii
m
ea
Before you call for service...
Troubleshooting tips
Oven light does not work
Possible Causes
Light bulb is loose or defective.
Plug on rm_ge is not completely
hlserted in the electrical outlet.
What To Do
• Tighten or replace
the bulb.
• Make sure electrical plug is plugged into a live, properly
grounded outlet,
Oven will not self-clean
The oven temperature is too
• Pdlow
the range to cool to room temperature and
high to set a self-cleml operation, reset the controls.
Oven conlrols improperly set. • See the
Using
the self-cleaning
oven section.
"Crackling" or
This is the somld of the • This is normal.
"popping" sound
metal heating and cooling
during both the cooking and
cleaning functions.
Excessivesmoking
Excessive soil. • Touch the
CLEAR/OFF
pad. Open the windows to
rid the room of smoke. _4ait tmtil the
LOCKED DOOR
light goes off. _4]l)e up the excess soil and reset the
clean cycle.
Oven door will not open
Oven too hot.
• _Mlow the
oven to cool below locking temperature.
after a clean cycle
Oven not clean after a Oven conwols not properly set. • See the Using the self-cleaning oven secti(m.
clean cycle
Oven was heavily soiled.
• Clean
up hea\ T spillovers befm'e starting the clean
cycle. Heavily soiled ovens may need to sell:clean
again or fin" a longer l)eriod of time.
"LOCK DOOR" flashes
The self-clean cycle has been
• Close
the oven door.
in the display
selected but the door is not
closed.
LOCKED DOORlight
The oven door is locked • Touch the
CLEAR/OFF
pad. Allow the oven to cool.
is on when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
"F--andanumberor
You have a ftmction error code. • Touch the CLEAR/OFF l)ad._Mlow the oven to cool tbr
letter" flash in the display one h(>ttL Put the oven back into operation.
If the function code repeats. • Disconnect all power to the range fin" 5 minutes
and then reconnect power. If the traction error
code repeats, call fin" service.
Oven shelves
are The nickel shelves (if so equipped) • Apply a small amount of vegetable oil to a paper
difficult to slide were dem_ed in a self-clema cycle, towel and wipe the edges of the oven shelves with
The gray porcelahl-coated shelves the pal)er towel. Do not spray with P;mf" or other
(if so equipped) were improperly lul_ricant sprays.
cleaned.
"Probe" appearsin
thedisplay(somemodels)
This is reminding you to enter a
probe temperature after plugging
ha the probe.
• Enter a probe temperatm'e.
g2