Maxtor OneTouch User Manual page 14

pop-up menu, as well as change the location of the installation
using the Install Location menu at the bottom of the screen.
8. When you are ready, click Install.
The installation will begin.
2
When the installation finishes, the Installation was successful
window should appear, asking you to Restart.
9. Click Restart.
10. After your Macintosh restarts, please eject the Maxtor Install
CD from your computer.
11. Proceed to the next section: Connecting the Drive.
Macintosh OS 9: Connecting the Drive
The Maxtor OneTouch Drive connects to your computer using the
FireWire interface.
Please install the software BEFORE you connect the drive.
Connecting the Power
1. Plug the round female connector from the power adapter into
the drive's power connector.
10
2. Plug the two-pin female connector on the power cord
into the power adapter.
Figure 5. Connecting the Power
3. Plug the standard electrical plug from the power adapter into
your power source.
4. Turn on the Maxtor OneTouch Drive using the power switch on
the back of the drive. The two blue lights on the front of the
drive should illuminate.
Connecting with the FireWire Cable
This section describes how to connect your OneTouch drive using a
FireWire cable. For more information about the FireWire interface,
go to http://www.askfor1394.com.
To connect the FireWire Cable
1. Plug one end of the FireWire cable into any available FireWire
port on your computer or any other FireWire device that is
connected to your computer.