Maxtor OneTouch User Manual page 10

6. Enter your Name and Password for your OS X system.
(This is the Name and Password you set up when you originally
installed OS X)
Click OK.
2
The Retrospect Express Installer will open.
7. Click Continue.
The license screen will appear.
8. Review license agreement and Accept to continue.
The Install Retrospect Express screen will appear.
9. This screen allows you to specify what type of installation you
want and where. It is automatically setup to do a Full
Installation (Recommended) into the Applications folder on
your Macintosh.
You can select a Custom Installation, using the Easy Install
menu, as well as change the location of the installation using
the Install Location menu at the bottom of the screen.
When you are ready, Click Install.
The installation will begin.
10. When the installation is complete, the Installation was
successful screen should appear, asking you to Restart.
11. Click Restart.
6
12. After your Macintosh restarts, please remove the Maxtor
Install CD from your computer.
13. Proceed to the next section: Connecting the Drive.
Macintosh OS X: Connecting the Drive
The Maxtor OneTouch Drive connects to your computer using the
FireWire interface.
Please install the software BEFORE you connect the drive.
Connecting the Power
1. Plug the round female connector from the power adapter into
the drive's power connector.
2. Plug the two-pin female connector on the power cord
into the power adapter.
Figure 3. Connecting the Power
3. Plug the standard electrical plug from the power adapter into
your power source.
4. Turn on the Maxtor OneTouch Drive using the power switch on
the back of the drive. The two blue lights on the front of the
drive should illuminate.