Cassette Tape - Play And Record; Basic Play; Tps (Tape Program Sensor); Before Recording - Panasonic PM31 - SC Micro System Operating Instructions Manual

Cassette tape – Play and record

Basic play

Basic play
Press [OPEN 0] on top of the unit.
1
Insert a cassette.
2
Forward side
Close the lid by hand.
3
3]
4 Press TAPE
[
To play the other side of the cassette, turn the cassette
over.
To
stop tape playback
start one touch play
fast-forward and
rewind

TPS (Tape Program Sensor)

TPS (Tape Program Sensor)
This function enables you to search the beginning of a track,
up to a maximum of 9.
Press [4/REW/ 4] or [3/FF/¢] during play.
Play resumes from the track found.
TPS may not function properly with:
• Short silent parts
• Noise occurs between tunes
• Silent parts found within tunes

Before recording

Before recording
Preparation
Wind up the leader tape so that recording can begin
immediately.
• Use normal position tapes.
• High position and metal position tapes can be used, but this unit
will not be able to record or erase them correctly.

Recording the radio

Recording the radio
Insert the cassette to be recorded on.
1
Tune to the required station (refer page 11).
2
3 Press [¶/8 REC] to start recording.
10
RQT7928
Insert inside the
guides
to start play.
Action
Press [CLEAR 7].
Press [TAPE 3] when the unit is OFF with
the cassette loaded.
Press [4/REW/4 ] or [3/FF/¢] in the
stop mode.

Recording CDs

Recording CDs
1 Insert the cassette to be recorded on.
Forward side
Press [CD 6] and then [STOP 7, –DEMO].
2
Press [0 OPEN/CLOSE] to insert the CD.
3
Press again to close.
Press [PLAY MODE] to select your desired mode
4
(refer page 7).
Press [¶/8 REC] to start recording.
5
Recording programmed tracks Recording programmed tracks
Program the tracks you want (refer page 8).
1
2 Press [¶/8 REC] to start recording.

Other basic operations

Other basic operations
To Action
erase a recorded 1) Insert the cassette to be recorded on.
2) Press [TAPE 3] and then [CLEAR 7].
sound
3) Press [¶/8 REC].
Press [CLEAR 7].
stop recording
stop recording 1) Press [¶/8 REC].
temporarily 2) Press again to resume recording.
record on the other Turn the cassette over and press
side of the tape [¶/8 REC].
Your attention is drawn to the fact that recording pre-
recorded tapes or discs or other published or broadcast
material may infringe copyright laws.
Erasure prevention Erasure prevention
The illustration shows how to remove the tabs to prevent
recording. To record on the tape again, cover as shown.
Side A
Tab for side B Tab for side A
Top of the unit

Cassette lid

Insert inside the
guides
To re-record
Normal tape
Adhesive tape