7.
Disconnect the power cable (1) and data cable (2) from the back of the hard drive.
Figure 6-27
8.
Remove the four screws that secure the hard disk drive to the hard drive cage (1), then slide the
hard disk drive out of the hard drive cage (2).
Figure 6-28
NOTE:
To install an internal 3.5-inch hard drive, refer to
on page
57.
56
Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis
Disconnecting the Hard Drive Cables
Removing the Hard Drive
Installing an Internal 3.5-inch Hard Drive