Operating Instructions; Lighting And Operating Label - Kenmore 33204 - Power Vent, 40 Gallon Owner's Manual

BEFOREOPERATING: E NTIRESYSTEMMUSTBEFILLEDWITHWATER ANDAIRPURGEDFROMALLLINES.
A. Thisappliance doesnothavea pilot. It isequipped with
an ignitiion device which automatically lights the
burner. Do no.i t try to light the burner by hand.
B. BEFOREOPERATING smell all aroundthe appliance
areafor gas. Be sureto smellnextto the floorbecause
somegas is heavierthanair andwill settleon the floor,
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electric switch;
do not use any phone in your building.
• Immediately callyourgassupplierfroma neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the
fire department.
C. Use only your hand to push in the gas control but-
tons. Never use tools. If the control buttonswill not
push in, don't try to repair them, call a qualifiedser-
vice technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately contact a qualified
installer or service agency to replace a flooded
water heater. Do not attempt to repair the unit.
It must be replaced!
WARM O O O
COOLER(_
8 1
_ HOTTER J
I
, )
1 STOP! Read the safety information above
on this label.
2. Set the ON/OFF switch on the control box to the
"ON" position.
3. Set the thermostat to the lowest settinq bv first
pressing the COOLER _ and HOTTER"_ but-
tons together and holding-for 1 second. Ther_press
the COOLER button (_ until the Warm indicator
light appears.
4. Set the ON/OFF switch on the control box to the
"OFF" position.
5. This appliance is equipped with a device
which automatically lights the burner.
DO NOT TRY TO LIGHT THE BURNER BY HAND.
6. Wait five (5) minutes to _ clear out any gas.
If you then smell gas_STOP! Follow "B" in
the safety information above on this label. If you
don't smell gas, go to the next step.
7. Turn on all electrical power to the appliance.
8. Set the ON/OFF switch on the control box to the
"ON" postition.
9. Set the thermostat to the desired setting bv first
pressing the COOLER (-,,) and HOTTER _ but-
tons together and holding-for1 second. Then press
the HOTTER button (_)
10.WATER TEMPERATURE ADJUSTMENT Vis
approximately 120°R
_ AUTION: Hotter water increases the risk of
scald injury. Consult the instruction
manual before changing temperature.
11.If the appliance will not operate, follow the instruc-
tions "TO TURN OFF GAS TO APPLIANCE" and
call your technician or gas supplier.
_ ARNING: TURN OFF ALL ELECTRIC
POWER BEFORE SERVICING.
1. Set the thermostat to the lowest setting b.yfirst
pressing the COOLER (--,) and HOTTER _ but-
tons together and holding-for 1 second. The_press
the COOLER button (_) until the Warm indicator
light appears.
2. Set the ON/OFF switch on the control box to the
"OFF" postition.
3. Turn offall electrical power to the appliance if
service is to be performed.
23