Upgrading The Firmware For The Spa400 - Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual

Connecting the Equipment
Installing the SPA400
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
SPA9000 Voice System Installation and Configuration Guide for Web UI

Upgrading the Firmware for the SPA400

In this procedure, you install any firmware updates that you downloaded in the
Preparation phase.
You need to repeat this procedure to upgrade each SPA400 individually.
Start Internet Explorer, and enter the IP address of the SPA400.
By default, the SPA400 is configured to obtain an IP Address via DHCP. You
NOTE
can check the obtained IP address on the router DHCP server's client list.
When the password prompt appears, enter the default user name, Admin, with no
password. Then click OK.
The user name must be entered exactly as shown: Admin. For information
NOTE
about managing system access, refer to the Cisco
Administration Guide
Click Administration tab > Firmware Upgrade.
Click Browse.
SPA400 Administration tab > Firmware Upgrade page
Find the binary (.bin file) that you extracted to your Desktop, and click Open.
.
4
SPA9000 Voice System
63