Nikon F75D - F75 QD = N75 35mm SLR Camera Body Only Instruction Manual page 56

Instruction manual
Table of Contents

Advertisement

Usable Optional Speedlights
in the LCD panel and
and
released when the exposure mode is set to P,
optional Speedlight is not set to TTL Auto Flash. Set the Speedlight flash mode to TTL,
or set the camera's exposure mode to S, A or M.
• When the attached optional Speedlight is turned on while Flash Cancel mode is
selected on the camera, the Flash Cancel indication in the LCD panel disappears and
attached Speedlight will fire flash. With some optional Speedlights, the Flash Cancel
indication does not disappear but the optional Speedlight will fire normally.
• With SK-6 and SB-24 attached, the AF-Assist Illuminators of the camera body and the
Speedlight do not emit light.
• In P or
exposure mode, the camera automatically controls the maximum available
aperture as follows in relation to the film speed:
ISO film speed
Maximum
Built-in Speedlight
available
Optional Speedlight
aperture
* When film speed increases by one step, the maximum available aperture is stopped
down by 1/2 f/stop. If you are using a lens with a maximum aperture smaller than that
listed above, the automatically controlled aperture range is from the lens' maximum
to minimum aperture.
• Use the optional Accessory Shoe Adaptor AS-15 to use the sync terminal.
110
—continued
in the viewfinder blink and the shutter cannot be
or Vari-Program and the attached
25
50
100
200
400
2
2.4
2.8
3.3
4
2.8
3.3
4
4.8
5.6
NOTE: When optional Speedlight is attached
Turn on the optional Speedlight power switch or set the built-in Speedlight to Flash
Cancel mode so the built-in Speedlight won't pop up automatically when an optional
Speedlight is attached. When the built-in Speedlight automatically pops up in
Vari-Program (except
Speedlight may not pop up all the way.
NOTE: Flash attachments made by manufacturers other than Nikon
Use only Nikon Speedlights. Other units may damage the camera's electrical circuit
due to incompatible voltage requirements (not compatible with 250V or higher),
800
electric contact alignment or switch phase. When flash attachments made by
4.8
manufacturers other than Nikon are attached, the built-in Speedlight may not pop up
all the way (with power switch of the Speedlight on or off). When the built-in
6.7
Speedlight is automatically fired in
or uneven illumination may result.
or
), vignetting or uneven illumination may result since the
or Vari-Program (except
www.mynikon.com.pl
or
or
), vignetting
111

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

F75F75d

Table of Contents