Remote Control Operation (Optional) - Nikon F75D - F75 QD = N75 35mm SLR Camera Body Only Instruction Manual

Remote Control Operation (optional)

Use the optional remote control to release the camera's shutter from a
distance. As with self-timer operation, the remote control can also be used
when you want to be in the photograph. You can also use the remote control
instead of a cable release to reduce camera shake.
NOTE: Before using the remote control
When using the remote control for the first time, make sure to pull out the insulation
sheet placed on the battery inside the remote control unit that is set when purchased.
1 Press the
number of times so
or
the LCD panel.
while pressing the
The display changes as follows:
• You can choose to release the shutter either immediately after ( ) or two sec. after ( )
the shutter release button on the remote control unit is pressed.
• Once remote control operation is set, the camera remains ready to receive a signal
from the remote control unit for 1 min. If no signal is sent for 1 min., the remote control
mode is cancelled and or disappears from the LCD panel.
• The remote control cannot be operated unless the camera's shutter can be released
(i.e. when subject is not in focus with autofocus).
• After the shutter is released, the camera remains ready to receive another signal from
the remote control unit for 1 minute.
: Standby duration for the remote control operation can be changed to 5 or
10 min. (p.76).
84
remote control button a
(immediate release)
(two-sec. delay release) appears in
(Or, rotate the Command Dial
remote control button.)
No display
(cancel)
Self-timer
2 Point the remote control unit toward the
camera and press the shutter release
button.
• When immediate release is selected, the self-timer
lamp lights after shutter release (except when the
Speedlight is used). When Red-Eye Reduction (page
93) is also set, the self-timer lamp lights at the same
Approx. 5m
output level as the normal Red-Eye Reduction before
the shutter releases and the flash fires when the
shutter is released.
• The shutter is released after the self-timer lamp lights
for approx. 2 sec. in two sec. delay mode. When Red-
Eye Reduction (page 93) is also set, the self-timer lamp
lights at the same output level as the normal Red-Eye
Reduction after the self-timer lamp lights for approx. 2
sec. and the flash fires when the shutter is released.
• To cancel the remote control operation, press the
button again or rotate the Command Dial while
pressing the
LCD panel. Or, turn the power switch off.
• To cancel the remote control operation after the shutter
release button is pressed and before shutter release,
turn the power switch off or press the
Focusing in remote control operation
Two methods to shoot with autofocus with remote control:
1. Autofocus activated by signal from remote control:
Shutter is released when (or two sec. after) the subject is in focus. However, when
focus cannot be achieved, it remains in standby mode.
2. Autofocus activated by lightly pressing shutter release button on the camera body
before remote control operation:
Lightly press the shutter release button on the camera body while the remote
control is standing by to achieve focus. Once focus is achieved, focus is locked
(even though the finger is removed from the shutter release button). Shutter is
released when (or two sec. after) the shutter release signal is received from the
remote control unit. The focus remains locked until remote control is cancelled.
button so or disappears from the
button.
www.mynikon.com.pl
85