Film Advance Mode - Nikon F75D - F75 QD = N75 35mm SLR Camera Body Only Instruction Manual

Film Rewind
This section explains mid-roll rewind and what to do if the film does not
rewind.
Mid-roll rewind
• To rewind film at mid-roll, press the two film rewind
Shutter sound is let out and film rewind will start.
•
during film rewind and the frame counter counts
backwards until rewind is complete.
• Film is completely rewound when a blinking
shows in the LCD panel and
appears without blinking and
the exposure meter is off.) Make sure
blinking, open the camera back away from sunlight
and remove the film cartridge.
If film does not start to rewind or film
rewind stops at mid-roll
• When battery power is very low, or at low
temperatures, film may not start rewinding or film
rewind may stop at mid-roll, and
number and insufficient battery power indication
will blink in the viewfinder. In this case, turn the
power switch off, change batteries, then turn the
power switch on to rewind film again. (The frame
counter display does not change until camera back
is opened once and closed again after removing the
film cartridge.)
be set not to appear (p. 74).
78
buttons simultaneously for approx. 1 sec.
, , and then appear in the LCD panel
in the viewfinder. (
disappears when
and
, frame
will blink in the LCD panel, and and
: Warning indications in the viewfinder can

Film Advance Mode

Two film advance modes, single-frame and continuous shooting are available
with the F75/F75D.
: Single-frame shooting
Fully pressing the shutter release button takes one picture and automatically
advances the film by one frame.
are
: Continuous shooting
Shots are taken continuously at the rate of up to approx. 1.5 fps as long as you
keep the shutter release button fully pressed.
Continuous shooting cannot be performed in flash photography.
Film advance speed is tested using camera settings of focus mode M, exposure
mode M, shutter speed 1/125 sec. or faster, aperture other than maximum, at
normal temperature of 20°C, with fresh batteries, for the 1st to 36th frames of a
film.
Set the film advance mode selector to
or .
www.mynikon.com.pl
79