Set Telephone Base Ringer; Set Remote Access Code - VTech CS5123 User Manual

• The handset
ringer volume is
set separately.
See page 9 for
details.
34
Answering system

Set telephone base ringer

This feature allows you to select the telephone base ringer volume level.
1. Press SET UP when in idle mode until the system announces the telephone
base ringer setting. There are three levels: HI (high), OF (off) and LO (low).
2. Press /SKIP or /REPEAT until the system announces the desired telephone
base ringer volume level, then press SET UP to save the setting and go to the
next setting, or press

Set remote access code

A two-digit security code is required to access the answering system from any
touch-tone telephone. The preset code is 19. You can set the remote access
code from 10 to 99.
To set the remote access code:
Press SET UP when in idle mode until the system announces the remote
1.
access code setting.
2. Press /SKIP or /REPEAT to change the remote access code by one, or
press and hold /SKIP or /REPEAT to change it by increments of ten.
SET UP to save the setting and go to the next setting, or press
to save and return to the idle mode.
www.vtechphones.com
/PLAY/STOP to save and return to the idle mode.
Press Press
/PLAY/STOP