Pr2 Mode - Epson C11C560111 - PLQ 20 B/W Dot-matrix Printer User Manual

PR2 mode

State of panel
lights
O Power
F Ready
O Power
O Offline
O Power
F Offline
O Pause
F Ready
F F1/Eject
F Offline
F F2
O = on, F = flashing
= short series of beeps (three beeps),
beeps)
62
Problem Solver
Beep Problem
pattern
Solution
— There is no paper loaded in the slot.
Load a paper into the front slot.
— Paper is not loaded correctly.
Remove the paper and reload it correctly. See
"Loading Passbooks" on page 17, or "Loading
Single Sheets" on page 19.
— Paper is not fully ejected.
See "Clearing Paper Jams" on page 74 for
instruction on ejecting paper.
— Paper is jammed in the printer.
To clear the paper jam, see"Clearing Paper
Jams" on page 74.
— The printer cover is open.
Stop the operation and close the printer cover.
— The print head is overheated.
Wait for a few minutes; the printer resumes
printing automatically once the print head
cools.
An unknown printer error has occurred.
Turn off the printer and leave it off for several
minutes; then turn on the printer again. If the
error recurs, contact your dealer.
= long series of beeps (five