Table of Contents
Advertisement
ge.com
i
i
i
i
i
i
Options
Thelight above the selected pad will be ON to indicate which OPTIONhas been selected.
HOT START
For use with heavily soiled and/or dried-on, baked-on soils. This optionMUSTbe
{on some
selected PRIORto starting the cgcle This option will improve both wash and dry
models}
performance. This option adds 20 minutes to the cycle time
NOTE:Cannot be selected with RINSEONLYcgcle,
HEATEDDRY
Shuts off the drging heat option, Dishes air drg naturallg and energg is saved,
Light OFF
Forfaster air drg you can prop the door open after the CLEANlight illuminates_
HEATEDDRY
Turns the heater on for fast drying This wil{ extend the total run time bg 38 minutes
Light ON
NOTE:Cannot be selected with RINSEONLYcgcle
D
LOCK
{onsome
models)
You can lock the centrals to prevent any selections from being mode Or you can tack
the controls after you have started a cycle
Childrencannot accidentoffg start dishwasher bg touching pads with this option
selected,
ToLOCK the dishwasher c ontrol,touchand holdtheHEATED DRYpad for3 secondsThelightbeiow
theHEATED D RY padwiltturnon To UNLOCK t he dishwashercontrol,touchand holdtheHEATED
DRY padfor 3 seconds, TheLOCK lightwillturnoff
HOT WASH
When selected, the cgcle will run longer with the heating element on to improve both
wash and dr# performance. NOTE:Cannot be selected with RINSEONLYcgde
DELAY HOURS
You con delog the start of a wash cgcle for 2, 4 or 8 hours {deiagtime options mog
vorg bg model), Touch the DELAYHOURSpad to choose the number of hours gou wont
to delog the start of the cgcte; then touch START/RESET one time, The dishwasher will
count down and start outomatico!tg at the correct time Touching START/RESET a
second time will cancel the DELAYETART selection,
RESET
To change a cgcte after washing starts, touch the START/RESET pod to cancel the
cgcle, The START/RESET l ight will flash while the water is pumped out if needed, This
takes approximotelg 90 seconds When the light stops flashing, the dishwasher can be
reprogrammed and restarted,
Start
Close and latch the dishwasher door and select the cgcle and desired enhancements Touch the
START/RESET pod once to begin the cgcle Water begins to fill the dishwasher, and approximately 60
seconds later the wash action begins, Touching the START/RESET p od o second time will cancel the
cgc{e and cause the water to drain out. This will take epproximgtefg 2 minutes,
NOTE:The dishwasher remembers your test cgde so gou don't hove to reprogrom each time When
the dishwasher door is fu{Ig closed, the control panel lights will displag the lost settings gou selected
If gou don't want to change ang of the settings, simplg touch the START/RESET pad once to begin
the cgcle
If the door is closed, the indicator lights will turn off if the START/RESET pad is not pressed within two
minutes, To activate the display, open and dose the door or touch ong pod,
Also, if a power failure occurs, NORHAL and HEATEDDRYwill outomoticallg be programmed
Advertisement
Table of Contents
