Epson Equity II Product Support Bulletin page 74

NUMBER:
S-0001C
PANASONIC
JU-595-10
COMMENT CODE EXPLANATIONS:
A. Requires insulating sheet when installed in lower position in
Equity See TIB Equity 11-006.
II.
B. Jumper block
C. Equity must have ROM BIOS version 2.21(MSA-B4) and MS-DOS 2.11
I
Release 1.04 or higher to use this drive.
D. Must set drive select jumpers on FDD logic board for A
(position S1) or B (position S2).
E. is not necessary
It
F. Handle drive with care - possibility of short circuit between
screw head on frame and FDD logic board (could damage FDD)!
G. Terminator must be removed when used as 2nd floppy drive unit.
H. See Product
Same as MD-5201-57
I.
Jumper block
J.
- Position DS0 for drive A, DS1 for drive B
SS1
to remove
Support Bulletin
except comes
- Position S1 for drive A, S2 for drive B.
JJ1
the terminating
S-0020 for set-up
configured as
PAGE: 2 of 5
resistor pack.
information.
2nd drive.