Epson Equity II Product Support Bulletin page 35

Are there any guidelines to installing the SlMMs in the Equity
Q13.
386/20?
A. Yes, when SlMMs are installed to increase memory beyond 1Mb,
they must be installed so that banks of SlMMs are installed as
matched pairs. See the matrix below:
Memory
1MB
2MB
4MB
4MB
8MB
10MB
16MB
Note:
Q14.
Is there a driver supplied with the Equity 386/20 to allow the use of
the extended memory as expanded memory?
A.
Yes, the Equity 386/20 system software includes the device driver
EEMM386EXE. This driver emulates LIM EMS 4.0 memory using
the extended memory supplied by the additional SIMMs. It will
support only the onboard memory above 1 MB, up to 15MB. This is
the maximum memory that can be installed on the CHET- RM
board. It will not support memory installed on memory expansion
boards.
Q15. Are there any expanded memory boards that are compatible with the
Equity LT?
A.
No, the option slots on the LT require a special connector. The
hard drive controller and the LT cartridge modem are the only option
cards currently available from Epson America.
Q16. What expanded memory boards are compatible with the Apex by
Epson?
A.
The Above Board PC from Intel Corporation has been tested by
Epson in the Apex.
Bank 0 Bank 1
4X256KB
4X256KB 4X256KB
4X256KB 4X256KB 4X256KB 4X256KB
4X1MB
4X1 MB 4X1 MB
4X1 MB 4X1 MB
4X1 MB 4X1 MB
Refer to PSB S - 0095 for 18MB RAM Setup information.
PSB No: S-0047C
Page:
Bank 2 Bank 3
4X256KB 4X256KB
4X1 MB 4X1 MB
5 of 6