Epson Equity II Product Support Bulletin page 53

There is one option for EQRAMDVR.SYS.
number from 1 to 4) after DEVICE=EQRAMDVR.SYS sets the number of
RAM disks that can be supported.
/2 will allow the Equity I to support two RAM disks.
option is omitted,- EQRAMDVR.SYS sets up support for one RAM disk.
When the system boots, EQRAMDVR.SYS
message similar to this:
RAM disk emulator
There will from one to four drive letters shown, depending on the
/n option. When you execute your RAM disk program, be sure to
use the drive letter shown in the sign on message.
using Tecmar's
the MS-DOS prompt:
MEMDISK D: -BUF160
This would set up a 160K RAM disk at drive D:.
If you attempt to use one of the EQRAMDVR.SYS drives before
running your RAM disk program, you will get one of the following
error messages:
Not ready error reading drive x
Abort, Retry,
or
Bad command error reading drive x
Abort, Retry,
The x would actually be the letter of the drive you tried to
access. Press A to abort, then run your RAM disk program.
EQRAMDVR.SYS
support installed
MEMDISK program, you would type this command at
Ignore?
Ignore?
OPTIONS AND OPERATION
Typing a /n (where n is a
In the instructions
will display
at drive(s)-C:,
above, the
If the /n
a sign on
D:
For example,
Page 7 of 9