Compaq dc5850 - Microtower PC Technical Reference Manual page 107

A.14 Hard Drive Error Messages (19xx-xx)
Message
19xx-01
19xx-02
19xx-03
19xx-04
19xx-05
19xx-06
19xx-07
19xx-08
19xx-09
19xx- 1 0
19xx- 1 1
19xx- 1 2
19xx- 1 3
19xx- 1 4
19xx- 1 5
19xx- 1 6
19xx- 1 7
19xx- 1 8
19xx- 1 9
19xx-20
1900-xx = Tape ID test failed
1901-xx = Tape servo write failed
1902-xx = Tape format failed
1903-xx = Tape drive sensor test failed
Technical Reference Guide
Hard Drive Error Messages
Probable Cause
Drive not installed
Cartridge not installed
Tape motion error
Drive busy error
Track seek error
Tape write-protect error
Tape already Servo Written
Unable to Servo Write
Unable to format
Format mode error
Drive recalibration error
Tape not Servo Written
Tape not formatted
Drive time-out error
Sensor error flag
Block locate (block ID) error
Soft error limit exceeded
Hard error limit exceeded
Write (probably ID ) error
NEC fatal error
Table A-13
Message Probable Cause
19xx-21 Got servo pulses second time but not first
19xx-22 Never got to EOT after servo check
19xx-23 Change line unset
19xx-24 Write-protect error
19xx-25 Unable to erase cartridge
19xx-26 Cannot identify drive
19xx-27 Drive not compatible with controller
19xx-28 Format gap error
19xx-30 Exception bit not set
19xx-31 Unexpected drive status
19xx-32 Device fault
19xx-33 Illegal command
19xx-34 No data detected
19xx-35 Power-on reset occurred
19xx-36 Failed to set FLEX format mode
19xx-37 Failed to reset FLEX format mode
19xx-38 Data mismatch on directory track
19xx-39 Data mismatch on track 0
19xx-40 Failed self-test
19xx-91 Power lost during test
1904-xx = Tape BOT/EOT test failed
1905-xx = Tape read test failed
1906-xx = Tape R/W compare test failed
1907-xx = Tape write-protect failed
www.hp.com
Error Messages and Codes
A-15