Table of Contents
Advertisement
2.5
Hard disk drives
The system supports two hot-swap Serial ATA hard disk drives.
To install a hot-swap SATA HDD:
1.
Release a drive tray by
pushing the spring lock to the
right, then pulling the tray
lever outward. The drive tray
ejects slightly after you pull
out the lever.
2.
Firmly hold the tray lever and
pull the drive tray out of the
bay.
3.
Take note of the drive tray
holes. Each side has three holes
to fit different types of hard
disk drives. Use two screws on
each side to secure the hard
disk drive.
4.
Place a SATA hard disk drive on
the tray, then secure it with
four screws.
2 - 1 2
2 - 1 2
2 - 1 2
2 - 1 2
2 - 1 2
C h a p t e r 2 : H a r d w a r e s e t u p
C h a p t e r 2 : H a r d w a r e s e t u p
C h a p t e r 2 : H a r d w a r e s e t u p
C h a p t e r 2 : H a r d w a r e s e t u p
C h a p t e r 2 : H a r d w a r e s e t u p
Advertisement
Table of Contents
