Chapter 2: Hardware Setup; Chassis Cover; Removing The Cover - Asus RS161-E2 - 0 MB RAM User Manual

2.1

Chassis cover

2.1.1 2.1.1

Removing the cover

Removing the cover
2.1.1 2.1.1 2.1.1 Removing the cover Removing the cover Removing the cover
1. Use a Phillips screwdriver to remove the screw on each front end of
the top cover.
2. Loosen the two thumbscrews on
the rear panel to release the top
cover from the chassis.
3. Remove the screws on both
sides of the chassis.
4. Firmly hold the cover and slide it
toward the rear panel for about
half an inch until it is disengaged
from the chassis.
5. Lift the cover from the chassis.
2 - 2 2 - 2 2 - 2 2 - 2 2 - 2
T h u m b s c r e w s T h u m b s c r e w s T h u m b s c r e w s
T h u m b s c r e w s T h u m b s c r e w s
1 / 2 i n c h d i s t a n c e 1 / 2 i n c h d i s t a n c e
1 / 2 i n c h d i s t a n c e 1 / 2 i n c h d i s t a n c e 1 / 2 i n c h d i s t a n c e
C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p