Table of Contents
Advertisement
2.4
Hard disk drives
RS700-E9-RS4
The system supports four (4) 2.5" or 3.5" hot-swap SATA/SAS hard disk drives. The hard disk
drive installed on the drive tray connects to the motherboard SATA/SAS ports via the SATA/
SAS backplane (SAS drives require an optional ASUS PIKE II card).
To install a 3.5" hot-swap SATA/SAS storage device:
1.
Push the spring lock to the right (A) then pull the tray lever outward (B) to release the
drive tray. The drive tray ejects slightly after you pull out the lever.
Tray lever
2.
Firmly hold the tray lever and pull the
drive tray out of the bay.
3.
Place the drive tray on a flat and
stable surface.
4.
Prepare the SATA/SAS storage
device and the bundled set of
screws.
ASUS RS700-E9 Series
Spring lock
2-9
Advertisement
Table of Contents
