Remote Control; Carrying The Unit; Placing The Unit - Sharp GX-M10HOR Operation Manual

■ Connecting iPod or iPhone to TV
Photo and video files from iPod or iPhone can be viewed
by connecting the system to TV/monitor.
If the TV/monitor has a video input, connect it to the VIDEO
OUT socket at the back of the unit and set the TV Out on
the iPod or iPhone unit to "ON" position.
Note:
Please make sure to set iPod unit to either NTSC or PAL to
match your TV signal. Please visit Apple's homepage for
further information.

Remote control

■ Battery installation
1 Open the battery cover.
2 Insert the supplied battery according to the terminal
indicated in the battery compartment.
When inserting or removing the battery, push it towards the
(–) battery terminals.
3 Close the cover.
Caution:
● Remove the battery if the unit will not be used for a long
period of time. This will prevent potential damage due to
battery leakage.
● Do not use rechargeable battery (nickel-cadmium battery,
etc.).
● Installing the battery incorrectly may cause the unit to
malfunction.
● Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
Notes concerning use:
● Replace the battery if the operating distance is reduced or
if the operation becomes erratic. Purchase an "AA" size
battery (UM/SUM-3, R6, HP-7 or similar).
● Periodically clean the transmitter on the remote control and
the sensor on the unit with a soft cloth.
● Exposing the sensor on the unit to strong light may interfere
with operation. Change the lighting or the direction of the
unit if this occurs.
● Keep the remote control away from moisture, heat, shock,
and vibrations.
■ Test of the remote control
Check the remote control after checking all the connections.
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown below:
Remote sensor
0.2 m - 6 m
(8" - 20' )
Note:
Exposing the infrared remote control to direct sunlight may
cause the remote control to be inoperable.
TIMER
REMOTE
SENSOR
E-5

Carrying the unit

Caution:
Before transporting the unit, remove the iPod, iPhone, iPad,
USB memory device and disc from the unit. Then, set the unit
to the power stand-by mode. Transporting the unit with iPod,
iPhone, iPad or USB memory device left connected or discs
left inside might damage the unit.
■ Using the carrying strap
This unit can be carried by using a supplied carrying strap.
Insert the carrying strap carabiner (hook) to each end of the
unit as shown below.
Carabiner (hook)
To remove the
carrying strap
Caution:
Before carrying the unit, make sure the carabiner (hook) is
properly secured and closed, otherwise it will cause damage
and injury.

Placing the unit

This unit can be placed in 2 positions as shown below.
Caution:
● Make sure that the unit is placed on a flat and level surface.
● Make sure to turn the unit carefully when adjusting the
position.
● Do not place the unit other than these 2 positions to avoid
damage and injury.
To get the best display viewing angle, place the unit as
below.
Position 1:
On the shelf/table.
Position 2:
On the floor/ground
Hole
Hole
Foot cushion 1 and 2
touching the surface.
Foot cushion 2 and 3
touching the surface.