Troubleshooting Chart - Sharp GX-M10HOR Operation Manual

Timer and sleep operation (Remote
control only) (continued)
Reusing the memorised timer setting:
The timer setting will be memorised once it is entered. To
reuse the same setting, perform the following operations.
1
Turn the power on and press and hold down the
CLOCK/TIMER button.
2
Within 10 seconds, press the
select "ONCE" or "DAILY", and press the ENTER button.
3
Within 10 seconds, press the
select "TIM.ON" , and press the ENTER button.
4
Press the ON/STAND-BY button to enter the power
stand-by mode.
■ Sleep operation
The radio, compact disc, iPod, USB, and Audio In function
can all be turned off automatically.
1
Play back the desired sound source.
2
Press the SLEEP button.
3
Within 5 seconds, press the Numeric button to set the
time. (1 minute ~ 99 minutes)
4
"SLEEP" will appear.
5
The unit will enter the power stand-by mode
automatically after the preset time has elapsed. The
volume will be turned down 1 minute before the sleep
operation finishes.
To confirm the remaining sleep time:
1
Whilst "SLEEP" is indicated, press the SLEEP button.
To cancel the sleep operation:
Press the ON/STAND-BY button whilst "SLEEP" is
indicated. To cancel the sleep operation without setting
the unit to the stand-by mode, proceed as follows.
1
Whilst "SLEEP" is indicated, press the SLEEP button.
2
Within 5 seconds, press the "0" button twice until
"SLEEP 00" appears.
■ To use timer and sleep operation together
Sleep and timer playback:
For example, you can fall asleep listening to the radio and
wake up to CD in the next morning.
1
Set the sleep time (see above, steps 1 - 5).
2
Whilst the sleep timer is set, set the timer playback
(steps 2 - 9, page 19).
Timer playback
Sleep timer
setting
setting
1-99 minutes
Sleep operation will
automatically stop

Troubleshooting chart

Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
■ General
or button to
● The clock is not set
or button to
● When a button is
● No sound is heard.
● Sound too low or
● Power suddenly
■ CD player
● Playback does not
● Playback stops in
● Playback sounds are
■ Remote control
● The remote control
■ Tuner
End
time
● The radio makes
Desired time
Timer playback
start time
E-20
Symptom
● A power failure occured.
to the correct time.
● Set the unit to the power
pressed, the unit
does not respond.
● If the unit still malfunctions,
● The volume level is set to
● The headphones are
● The batteries are depleted.
distorted.
shuts down.
Symptom
● The disc is loaded upside
start.
● The disc does not satisfy
the middle or is not
● The disc is distorted or
performed properly.
● The unit is located near
skipped, or stopped
● A very dirty disc has been
in the middle of a
track.
● Condensation has formed
● Volume level is too high.
Symptom
● The AC power lead of the
does not operate.
● Wrong battery polarity.
● The batteries are
● The distance or angle is
● The remote control sensor
Symptom
● The unit is placed near the
unusual noises
● The FM aerial is not
continuously.
Possible cause
Reset the clock. (Refer
page 6)
stand-by mode and then
turn it back on.
reset it. (Refer page 21)
"MIN".
connected.
Change the batteries.
Possible cause
down.
the standards.
scratched.
excessive vibrations.
used.
inside the unit.
Adjust to lower volume.
Possible cause
unit is not plugged in.
exhausted.
incorrect.
receives strong light or
sunlight.
Possible cause
TV or computer.
properly extended or
positioned.