Create Waypoint On Map; Navigate To A Waypoint - Eagle Cuda 250i S/Map Installation And Operation Instructions Manual

Create Waypoint on Map

1. Use the arrow keys to move the cursor to the place where you want
to make a waypoint.
2. Press |
WPT
name with a sequential number, such as "waypoint 001." The waypoint
symbol and number appear on the map.
Create Waypoint by Entering a Position
, then use → to select
1. Press
WPT
2. Press ↓ to
E
3. Press ↓ to
change the first character, then press → to the next character and re-
peat until the latitude is correct. Press
4. Press ↓ to
change the first character, then press → to the next character and repeat
until the longitude is correct. Press
previous page display. The waypoint is saved and automatically given a
name with a sequential number, such as "waypoint 001." The waypoint
symbol and number appear on the map and in the waypoint list.

Navigate To a Waypoint

You can select any waypoint visible on the Map Page with the cursor,
then use the Navigate to Cursor command. You, however, can avoid
scrolling the map to pick your waypoint if you use the Find Waypoint
commands:
1. Press |→ to
WPT
or to look by name press ↓|
ENT
2. If your waypoint list is a long one, you can spell out the waypoint
name in the
F
then press → to move the cursor to the next character and repeat until
the name is correct, then press
. The waypoint is saved and automatically given a
WPT
P
NTERED OSITION
|
L ENT
ATITUDE
|
L ENT
ONGITUDE
|
S ENT
AVED
box. Press ↑ ↓ to change the first character,
B N
IND Y AME
as the Subcategory|
N
EW
| |↑ to
ENT C
REATE
. Enter the latitude by pressing ↑ or ↓ to
ENT
. Enter the longitude by pressing ↑ or ↓ to
, then
ENT
. To look up the nearest waypoint, press
. For this example, look by name.
ENT
to jump to the list below.
ENT
104
| .
ENT
.
| to return to the
EXIT EXIT
.
ENT