Mounting In Portrait Position; How To Use The Logo Guider For Portrait Position; How To Remove The Logo - Philips BDL4645E/00 User Manual

BDL3245E / BDL4245E / BDL4645E
1.6.

Mounting in Portrait Position

This display can be installed in portrait position.
1. Remove the table stand, if attached.
2. Rotate 90 degrees clockwise. The "

1.6.1. How to use the logo guider for portrait position

1. Put the guider on the lower-left corner of the front bezel of the display.
Fold down both of its edges.
2. Peel off the protective film at the back of the "
Hold and press the guider with your left hand. Put the "
sticker with its adhesive side down into the logo hole with your right
hand, and press to make it stick tightly onto the front bezel.
3. Remove the guider.

1.6.2. How to remove the logo

1. Prepare a piece of paper with a cutting area of logo as a protector to
prevent the front bezel from scratching.
2. Using a knife, carefully remove the logo sticker with the paper placing
beneath.
3. Tear off the logo sticker.
NOTE: When installing the display on a wall, please consult a professional technician for proper installation. We accept no liability for installations not
performed by a professional technician.
" logo should be on the LEFT side when facing the display.
90
" logo sticker.
" logo
4
90
1 2
2
1
3
3