Power Management - Canon Wireless File Transmitter WFT-E2 II A Instruction Manual

Wireless file transmitter for use with eos-1d mark iii or eos-1ds mark ii

Hide thumbs Also See for Wireless File Transmitter WFT-E2 II A:

Table of Contents

Connecting External Media

Unplugging External Media from the USB Port

Before unplugging external media from the USB port, always select [Disconnect] as shown in

step 5. Follow the instructions displayed to terminate the connection.

The connection will not be terminated if you simply turn off the camera and external media. If

you unplug external media while the connection is still active, plug the external media into the

USB port again and follow the preceding steps to terminate the connection.

Power Supply to External Media

External media is powered via the transmitter's USB port as needed. However, external hard

disk drives may not work after connection in some cases.

Power Management

If you will not use a wireless or wired LAN at the

same time as the external media, set

[Communication mode] to [Disconnect]. The

camera battery drains faster under settings other

than [Disconnect] because power saving is

disabled.

Setting [Power saving] to [Enable] enables the

power supply to external media to be stopped

automatically, conserving the camera battery.

Power is supplied again automatically during

shooting, when captured images are stored.

Table of Contents