Troubleshooting Guide - Canon EOS Rebel T4i 18-135mm IS STM Lens Kit Instruction Manual

Troubleshooting Guide

If a problem occurs with the camera, first refer to this Troubleshooting
Guide. If this Troubleshooting Guide does not resolve the problem,
contact your dealer or nearest Canon Service Center.
Power-Related Problems
The battery pack does not recharge.
Do not recharge any battery pack other than a genuine Canon Battery
Pack LP-E8.
The battery charger's lamp blinks.
If there is a problem with the battery charger, the protective circuit will
stop the charging operation and the charge lamp will blink in orange. If
this happens, disconnect the charger's power plug from the power
outlet and remove the battery pack. Attach the battery pack to the
charger again and wait a while before connecting the charger to a
power outlet again.
The camera does not operate even when the power switch
is set to <1>.
Make sure the battery is properly installed in the camera
Make sure the battery compartment cover is closed
Make sure the card slot cover is closed
Recharge the battery
Press the <B> button
The access lamp still blinks even when the power switch is
set to <2>.
If the power is turned off while an image is being recorded to the card,
the access lamp will remain on/continue to blink for a few seconds.
When the image recording is completed, the power will turn off
automatically.
320
(p.28)
.
(p.50)
.
(p.30)
(p.31)
.
(p.30)
.
.