en
The P icon lights up when the child
lock is activated. At this point the
water heater is deactivated, but you
P
can still draw ambient water. To
learn more about this setting, read
the section titled "Child lock".
M and N flash at the same time
M
if there has been no hot water
drawn for some time. For hygienic
+
N
reasons, set the temperature to
90°C or Q and draw hot water (1 x).
Extinguish M and N ; the tempera-
ture last set lights up.
Using the appliance
General
With this appliance, you can filter water and
dispense it at room temperature or heated
to specific temperatures.
If you have questions regarding the filter
cartridge, contact the BRITA Consumer
Service at 0844 742 4800 (toll-free).
Note: The appliance is checked before
delivery, which means there may be some
isolated drops of water found. These drops
of water are harmless, simply remove with
a cloth.
Setting up the appliance
Before you use the appliance for the first
time, do the following:
Remove film.
►
Unroll or push in the right amount of
►
cable from the cable compartment and
plug the cable into a power outlet.
Remove the water tank and clean it
►
thoroughly under running water.
Insert the filter cartridge as described in
►
the section titled " BRITA MAXTRA water
filter system".
Fill the water tank up to the max mark
►
with fresh, cold water. Use only non-
carbonated drinking water.
Replace the water tank and push it firmly
►
downward into place.
Set the on/off switch to on. All display
►
items will light up briefly, and then the
90°C icon stays lit.
Place a glass or cup holding at least
►
150 ml on the cup stand under the water
outlet.
Press the start/stop button to dispense
►
one portion of water to rinse the
appliance.
Note: Before using the appliance for the
first time or after a long period of non-use,
do not drink the first two glasses of water.
The machine is now ready to use.
Dispensing water
Set the cup stand to the appropriate
►
height for the cup or glass.
Place the cup or glass under the water
►
outlet.
Press the temp. set button to select the
►
desired temperature.
Press the start/stop button. The
►
water will dispense from the outlet. The
selected temperature flashes while the
water is dispensed.
Height adjustment
The adjustable cup stand lets you adjust
the distance between your cup or glass and
the water outlet. The lowest setting is suit-
able for taller glasses and cups. For smaller
cups or soup cups you can insert the cup
stand into one of the upper openings.
Important: Don´t use the appliance without
the cup stand.
5
THD20.. 06/2012