Table of Contents
Advertisement
6
Fill quantity
The appliance ships with a preset fill
quantity of 250 ml. You can change this
quantity.
To adjust the fill quantity, proceed as
follows:
Hold down the temp. set button for at
►
least 5 seconds.
The indicator for the currently set fill
►
quantity flashes.
Press the temp. set button to select the
►
desired fill quantity:
L
= approx. 120 ml
70 °C
= approx. 150 ml
80 °C
= approx. 200 ml
90 °C
= approx. 250 ml
Q
= approx. 300 ml
Press the start/stop button – the setting
►
is now stored.
Important: To keep the dispensed water
from overflowing, make sure that you place
a sufficiently large glass or cup under the
water outlet.
Note: To change this setting at any time,
repeat the above procedure.
Child lock
For safety reasons, this appliance is
equipped with a child lock. To activate it,
proceed as follows:
Press and hold the temp. set and start/
►
stop buttons simultaneously for at least
5 seconds. The L and P icons light up .
Info: When the child lock is activated, only
ambient water is available. When you press
the temp. set button, the L flashes; all
other settings are blocked.
To deactivate the child lock, proceed as
follows:
Press and hold the temp. set and start/
►
stop buttons simultaneously for at least
5 seconds. The P icon goes out.
Robert Bosch Hausgeräte GmbH
BRITA MAXTRA water
filter system
In models equipped with a water filter
system, only BRITA MAXTRA water
filter cartridges may be used.
BRITA MAXTRA cartridges can be
purchased from retailers or directly from
Bosch Customer Service. (See the back
pages of these instructions for contact
information).
The appliance can be used with or without
a filter cartridge.
Keep in mind that you will enjoy the bene-
fits of BRITA filtration only if a MAXTRA
filter cartridge is installed in the appliance.
Tea and coffee also have more aroma
when prepared with fresh, BRITA-filtered
water.
To use the machine without a filter, simply
remove the filter holder and the filter
cartridge and adjust the machine settings
accordingly.
Important: The Filter Yes/No setting
controls the filter replacement indicator.
Changing the filter setting
Turn the appliance off with the on/off
►
switch.
Press and hold the temp. set button.
►
Turn the appliance back on with the on/
►
off switch – the M icon flashes.
Press the start/stop button to select the
►
Filter Yes/No setting:
Yes = M lights up
or
No = M does not light up
Release the temp. set button – the set-
►
ting is now stored, and the most recently
selected temperature lights up.
Note: To change this setting at any time,
repeat the above procedure.
After setting the filter to "yes", the symbol
M will light up after a certain time during
operation. The BRITA MAXTRA filter
cartridge is exhausted and needs to be
changed.
en
Hide quick links:
Advertisement
Table of Contents
